DIY in 10 Minutes: Reclaimed timber jewelry Holder

DIY in 10 Minutes: Reclaimed timber jewelry Holder

Practicality you didn’t even comprehend you essential.

This effortless venture prices pennies and adds rustic attraction to any decor. dangle it in a rest room or above a dresser in the bed room to retain your necklaces untangled and organized (additionally, so that you don’t forget to put on them). The piece of wood used during this assignment was found on the seaside. try taking aside a pallet or sourcing reclaimed timber for your area.

supplies:

Plank of timber, drill with ¼” bit, knobs (discovered at Anthropologie for about $5.00), hammer and nails.

Step 1. Wipe down the plank with a fabric and some timber soap and take away any historical nails.

Step 2. Drill holes where you possibly can like the knobs to be. make sure your drill bit is the size of the knob screw.

Step 3. Screw the knobs into the plank of wood. if your knob screws are longer than the plank of timber in the again, you're going to need to saw them off. It depends upon the category of knob and thickness of the timber you have got.

Step four.  attach it to the wall with a hammer and nails. (You gained’t should be concerned about discovering a stud because the rings holder is light-weight. (if you're going to hold heavier objects, like jackets, you're going to need to use screws and locate the stud.)

Voila!

also check out:

The ultimate DIY gift: Mason Jar photo CandlesDIY: A Holder for shades You can make in 10 MinutesDIY: A Clock You can make in 10 Minutes

Tags: 10 minute diy, DiY home accessories, DIY task, jewelry holder, rings organizer, salvaged wood, sofie sausser
DIY in 10 Minutes: Reclaimed timber jewelry Holder Practicality you didn’t even comprehend you essential. This effortless venture prices pennies and adds rustic attraction to any decor. dangle it in a rest room or above a dresser in the bed room to retain your necklaces untangled and organized (additionally, so that you don’t forget to put on them). The piece of wood used during this assignment was found on the seaside. try taking aside a pallet or sourcing reclaimed timber for your area. supplies: Plank of timber, drill with ¼” bit, knobs (discovered at Anthropologie for about $5.00), hammer and nails. Step 1. Wipe down the plank with a fabric and some timber soap and take away any historical nails. Step 2. Drill holes where you possibly can like the knobs to be. make sure your drill bit is the size of the knob screw. Step 3. Screw the knobs into the plank of wood. if your knob screws are longer than the plank of timber in the again, you're going to need to saw them off. It depends upon the category of knob and thickness of the timber you have got. Step four.  attach it to the wall with a hammer and nails. (You gained’t should be concerned about discovering a stud because the rings holder is light-weight. (if you're going to hold heavier objects, like jackets, you're going to need to use screws and locate the stud.) Voila! also check out: The ultimate DIY gift: Mason Jar photo CandlesDIY: A Holder for shades You can make in 10 MinutesDIY: A Clock You can make in 10 Minutes Tags: 10 minute diy, DiY home accessories, DIY task, jewelry holder, rings organizer, salvaged wood, sofie sausser

Previous post Next Post

Comments

Leave a comment

Our Brand